Wifi sync stop working

[Jenda]

Hi,

I have problem with wifi sync of my vault.

I have Mac Catalina 10.15.7, Enpass version 6.11.2

I click to start server, click to vault and qr code is created, but when i scan it, it wrote no vault.

Also the manual sync information are not usefull because the varification code is different.

I also see that the server has no port.

The Enpass wrote in corner: Synchronization faild - Target folder for synchronization is not reachable.

It did work before. I did not install anything new, just system updates.

I check firewall, access to the disk or folders.

I dont have the wifiyncserver_bin in mac firewall, only Enpass app.

I thing the server did not start. Can you help me with that?

Edited August 29 by Jenda

[Jenda]

ok. I stop sync server. Go to the Enpass app content and find the file wifisyncserver_bin and run. Then go to Enpass app and start server again. Now there is port and sync start working.

[Jenda]

Ok. The problem still persist, the message. "Target folder..." is still there and the mobile device dont see the vault.

Any help?

[Amandeep Kumar]

We would suggest you disconnect the Wifi-Sync server from the connected devices and set it up by following the steps in the link - https://www.enpass.io/wifi-sync/ , or manually by following the steps in this link - https://www.enpass.io/wifi-sync-manual-setup/  .
If you have any additional questions or require further assistance, please mail us at support@enpass.io

[Jenda]

Hi,

I stop the server

and run the server.

But you can see the error message appears immediately.

So I remove the vault.

Stop and start the server again.

no error message

Then scan the code -> error

Manual set-up. but there is no verify code and there is again the error message with the transfer vault to sync folder

 

 

Edited September 6 by Jenda

[Tarun Singh Rawat]

I've reported this issue to the Enpass technical team. They are currently investigating it, and I will reach out to you with updates as soon as I receive them.

#SI-3998